Skip to notes
9476 / 2027
Data and Experimental Skills

Lesson 7 of 11

Thermometric titration

Find an end-point from where two temperature trends meet.

A-Level 9476 (2026-2027)

  • I can explain thermochemistry.Syllabus

    Syllabus 9476, T4. Thermochemistry

Find the end-point where two temperature lines meet

The end-point is where the rising and falling temperature lines meet, which can lie between two readings.

Make a guess. You are not marked.

Alkali is added in portions to an acid, and the temperature is read after each portion. What happens to the temperature after the end-point?

  1. It keeps rising at the same rate
  2. It stops rising and falls slowly
  3. It drops back to room temperature at once
Show the answer

It stops rising and falls slowly

No acid is left, so no more neutralisation heat is released. Cooler added alkali and heat loss to the surroundings lower the temperature.

In a thermometric titration, add measured portions of titrant, mix consistently and record temperature against the cumulative added volume. For an exothermic neutralisation, temperature initially rises as reaction releases energy. Once the limiting reagent is used up, further titrant produces no further neutralisation heat; dilution and heat exchange can lower the temperature. Estimate equivalence by extending the appropriate before- and after-reaction trends to their intersection.

The temperature change is the rise from the starting temperature to the temperature where the lines meet. Do not report the meeting temperature itself as the change.

Estimate the endpoint between measured additions

Six illustrative measurements lie on two local trends. The rising trend passes through volumes 8, 12 and 16 cubic centimetres. It meets the falling trend, through 24, 28 and 32, at 20 cubic centimetres and 24 degrees Celsius. No reading was taken exactly at that intersection.

Dots are illustrative observations; dashed extensions estimate the intersection. The two straight segments are local approximations, not a universal temperature-volume law.

Worked exampleRead the intersection, not just the highest measured point

Near the endpoint, the fitted trends in the graph are T = 22.0 + 0.100V and T = 24.5 - 0.0250V. T is in °C and V in cm3. Estimate the reacting volume.

Try it first. Then show the worked stepsHide the worked steps
  1. At the intersection, the temperatures agree: 22.0 + 0.100V = 24.5 - 0.0250V.
  2. 0.125V = 2.50, so V = 20.0 cm3 and T = 24.0 °C.
  3. The highest measured point is at 24 cm3, where T = 23.9 °C. Choosing that addition as the endpoint would miss the intersection between measurements.
  4. Use the inferred volume with the balanced reacting ratio if calculating concentration. Inspect whether straight trends are justified: changing solution mass, heat loss, dilution or a slow response can cause curvature. Smaller volume increments near the endpoint and consistent mixing and timing improve the evidence.
Answer

Estimated equivalence volume: 20.0 cm3. The construction is justified by the two local trends and their assumptions.

The end-point is where the two best-fit lines cross. So more points near it fix both lines, and the place where they cross, more precisely.

The method is over a century old. J. M. Bell and C. F. Cowell reported one of the earliest thermometric titrations in 1913, in the Journal of the American Chemical Society.

Check your understanding

Why add smaller portions of titrant close to the expected end-point in a thermometric titration?

  1. Smaller portions stop heat being lost to the surroundings
  2. More points there pin down where the lines meet
  3. Smaller portions release more heat for each cm3 added
Show the answer

More points there pin down where the lines meet

The end-point is found from where the lines meet. More points close to it show each trend more clearly.

Watch out for this

A student says: "The mixture started at 21.5 degrees C and the two lines meet at 27.0 degrees C, so the temperature change is 27.0 degrees C." What is wrong with this?

Show the answer

The change is the rise from the start: 27.0 - 21.5 = 5.5 degrees C. June 2022 and June 2023 Cambridge reports say some candidates used the maximum temperature rather than the change in temperature.