Lesson 2 of 11
Graphs and calculations
Turn numbers into a trend, gradient or justified result.
A-Level 9476 (2026-2027)
I can present data in an appropriate, useful form.Syllabus
Syllabus 9476, PDO. Present data in an appropriate, useful form
I can analyse, conclude and evaluate.Syllabus
Syllabus 9476, ACE. Analyse, conclude and evaluate
I can explain chemical kinetics.Syllabus
Syllabus 9476, T5. Chemical kinetics
Turn measurements into a graph or calculation
Keep the meaning of each axis, ratio and unit visible.
Make a guess. You are not marked.
A graph plots gas volume in cm3 against time in s. What unit does its gradient have?
Show the answer
cm3 s-1, a volume per unit time
A gradient is the change in y divided by the change in x. So its unit is the y unit divided by the x unit. Here it is a rate of gas production.
Put the independent variable on the horizontal axis and the measured or derived dependent variable on the vertical axis. Label each axis with a quantity and unit, use a clear uniform scale, and plot the actual points. A best-fit line or smooth curve represents a trend; do not force it through every point or through the origin without a reason. A point that does not fit the pattern is anomalous: circle it, and leave it out when you draw the line.
| Time / s | Gas volume / cm3 |
|---|---|
| 0 | 0 |
| 20 | 24 |
| 40 | 39 |
| 60 | 45 |
| 80 | 48 |
An interval rate is a gradient between two points
Between 20 and 40 seconds, gas volume increases from 24 to 39 cubic centimetres. The horizontal change is 20 seconds and the vertical change is 15 cubic centimetres. The curve becomes less steep later.
Worked exampleCalculate and interpret a gradient
Find the average gas-production rate between 20 and 40 s.
Try it first. Then show the worked stepsHide the worked steps
- Change in gas volume = 39 - 24 = 15 cm3.
- Time interval = 40 - 20 = 20 s. Average rate = 15 / 20 = 0.75 cm3 s-1.
- This is an interval average. A rate at one instant is the gradient of a tangent to the curve at that instant, where required.
0.75 cm3 s-1. The graph later becomes flatter, so the gas-production rate decreases.
Interpolation estimates a value within the measured range. Extrapolation extends a trend outside it and needs an extra assumption that the relationship continues. If a graph is linear, find the gradient from two well-separated points on the best-fit line. Do not choose two close points just because they are measurements.
Keep guard digits during working. Round the final answer to a precision justified by the inputs and any question instruction. A unit conversion changes the numerical value, not the physical quantity: 25.0 cm3 = 0.0250 dm3. Check dimensions before inserting numbers into a formula.
Units matter at every step. In September 1999, NASA lost its Mars Climate Orbiter. One piece of software, supplied by Lockheed Martin, gave its results in US customary units, while NASA's system expected SI units.
Check your understanding
A gas-volume curve is high but nearly horizontal. Does its height show a high rate at that moment?
Show the answer
No. Height shows gas made so far; the flat gradient shows a low rate now.
The rate at a moment is the gradient of the curve. A high, flat curve means a lot of gas has been made but very little is being made now.
Watch out for this
A student says: "To find the gradient of a straight best-fit line, use two rows from the results table." What is wrong with this?
Show the answer
Read two points that lie on the line itself, far apart, and write them as (x, y). A measured point may sit off the line. A November 2022 Cambridge report says some candidates lost marks by using table values that did not fall on the line of best fit.