Lesson 4 of 6
Distillation and liquid layers
Use boiling-point differences or immiscibility.
SEC G2 Science K223 / K225 (2027)
I can describe separation methods.Syllabus
Syllabus K223 / K225, 1.2(a). Describe separation methods
I can choose methods from properties.Syllabus
Syllabus K223 / K225, 1.2(b). Choose methods from properties
Distillation and liquid layers
Distillation boils off the part with the lower boiling point, then cools it back into a liquid.
Make a guess. You are not marked.
A mixture of ethanol (boiling point 78 degrees C) and water (boiling point 100 degrees C) is heated slowly in fractional distillation. Which liquid collects first?
Show the answer
Mostly ethanol, as it boils at a lower temperature
Ethanol has the lower boiling point, so its vapour reaches the top of the column first while most water condenses and drips back.
Distillation separates a liquid by boiling it off and then cooling the vapour back into a liquid. Simple distillation gets a solvent back from a solution, such as pure water from salt water. Heat the salt water: the water boils, but the salt does not. The steam passes into a condenser, a tube cooled by a jacket of cold water. There it condenses into pure water, called the distillate. The salt stays in the flask.
Put the thermometer bulb level with the side-arm, so it reads the temperature of the vapour entering the condenser. Cold water enters the condenser at the bottom and leaves at the top. This keeps the jacket full of cold water.
Fractional distillation separates miscible liquids, which mix completely and do not form layers, such as ethanol and water. It works because their boiling points are different: ethanol boils at 78 °C and water at 100 °C. These are too close together for simple distillation to separate them well, so a fractionating column is fitted above the flask.
In the column, vapour condenses and boils again many times. Each time, the vapour gets richer in the liquid with the lower boiling point. So vapour that is mostly ethanol reaches the top, while most of the water condenses and runs back into the flask. The thermometer stays near 78 °C while ethanol distils. When it rises towards 100 °C, most of the ethanol has gone and water is coming over.
Oil refineries use the same idea on a giant scale. Crude oil is a mixture of hydrocarbons, compounds of carbon and hydrogen only. At ExxonMobil's refinery on Jurong Island, Singapore, fractional distillation splits crude oil into fractions. Each fraction is still a mixture of compounds with boiling points in a similar range.
Check your understanding
You need pure water from seawater. Why choose distillation rather than evaporation to dryness?
Show the answer
Distillation condenses and collects the water vapour; evaporation lets it escape.
Both methods boil off the water, but only distillation cools the vapour back into liquid and collects it. Evaporation keeps the salt and loses the water.
Check your understanding
What is the job of the fractionating column when ethanol and water are separated?
Show the answer
It separates the liquids, as most of the water vapour condenses there and runs back
The column gives many rounds of condensing and boiling. So the vapour that leaves the top is rich in ethanol, the liquid with the lower boiling point.
Watch out for this
A student says: "In the fractional distillation of ethanol and water, ethanol distils first because it has a low boiling point." What is wrong with this?
Show the answer
Compare the two liquids. Ethanol distils first because its boiling point, 78 degrees C, is lower than that of water, 100 degrees C. "A low boiling point" does not say what it is lower than. Examiners report "has a low boiling point" as the most common error when explaining which liquid is collected first. Write "lower" or "lowest", and say what you are comparing with.