9478 / 2027
Circuits overview

Lesson 3 of 15

Measuring resistivity

  • I can recall and use R = rho l/A for a uniform conductor under stated conditions.Syllabus

    Syllabus 9478, 16(d). Recall and use R = rho l/A for a uniform conductor under stated conditions.

Make a guess. You are not marked.

A student's diameter reading for a wire is 1% too large. About how far out is the resistivity they calculate?

  1. About 1% too small, because area divides in R = rho l/A.
  2. About 2% too large, because the area uses d2.
  3. About 1% too large, the same as the diameter.
Show the answer

About 2% too large, because the area uses d2.

A = pi d2/4, so a 1% error in d gives about a 2% error in A. Since rho = RA/l, rho is also about 2% too large.

Measure R for several lengths of the same wire and plot R against l. The gradient is ρ/A, so multiply it by the measured area to find the resistivity.

  1. Set up a uniform wire with a low-voltage supply, a variable resistor, an ammeter in series and a voltmeter across the chosen length.
  2. Measure the diameter with a micrometer at several places and in different directions. Check its zero first.
  3. Choose the meter ranges from an estimate. A 0.125 A current needs more than a 0 to 0.1 A range.
  4. Vary the length between the contacts. For each, record V and I and work out R = V/I. Keep the current small so the wire does not warm up.
  5. Plot R against l. The gradient is ρ/A, so ρ = gradient × A.

For the wire in the last lesson, the gradient would be 3.20/0.800 = 4.00 Ω/m. Times A = 1.2566 × 10-7 m2, that gives ρ = 5.03 × 10-7 Ω m.

Judge the errors

The contacts and leads add a small, fixed resistance. On the graph, that shows up as an intercept, while the gradient stays right. So do not force the line through the origin.

The diameter is squared, so a 1% error in d gives about a 2% error in A, and so in ρ. Repeats show scatter, but they cannot fix a micrometer with a zero error.

A real example. In 1913 the International Electrotechnical Commission adopted the International Annealed Copper Standard. A NIST report gives its resistivity as 1.7241 microhm-centimetre at 20 °C, which is 1.7241 × 10-8 Ω m. Wire makers still rate copper against it.

The gradient of R against l is not the resistivity. It is ρ/A, in Ω/m, so you must multiply it by the area.

Check your understanding

A student plots R against l for a uniform wire of cross-sectional area 1.26 x 10-7 m2. The gradient is 4.00 ohm per metre. Which of these is the resistivity?

  1. 4.00 ohm m, the gradient itself
  2. 3.17 x 107 ohm m
  3. 5.04 x 10-7 ohm m
Show the answer

5.04 x 10-7 ohm m

R = (rho/A)l, so the gradient is rho/A. Then rho = gradient x A = 4.00 x 1.26 x 10-7 = 5.04 x 10-7 ohm m.