K223 / K224 / 2027
D.C. circuits overview

Chapter revision

Revision summary

Key ideas, equations and common mistakes. Open any topic below for the full explanation.

Symbols and connections

Use the standard symbols and follow each part's two end points. A dot marks a junction. Series parts share one path and one current. Parallel branches share both end points and so have the same p.d. A redrawn circuit is the same circuit only if every connection is unchanged.

Series
I = I1 = I2 = ...; Vs = V1 + V2 + ...; Rseries = R1 + R2 + ... . The same current does not mean the same p.d.
Parallel
V1 = V2 = ... = Vgroup; Itotal = I1 + I2 + ...; 1/Rparallel = 1/R1 + 1/R2 + ... . Take the reciprocal after adding. For two resistors, Rparallel = R1R2/(R1 + R2).
One part or one group
V = IR, using its own p.d. and current. In these examples the wires have no resistance and the supply is ideal. Vs is the p.d. across the whole circuit outside the supply.

Solve, change and test a circuit

  1. Find the nodes and a series or parallel group.
  2. Replace the group by its equivalent resistance, keeping its two end points.
  3. Find the total resistance and the supply current.
  4. Work back to the p.d. across each group and the current in each branch.
  5. Check that currents add up at each junction and that p.d.s add up along each path.

Opening a branch that is straight across a fixed supply leaves the other branches unchanged. Opening a branch inside a larger circuit can change the p.d. across the branch that is left. Work the circuit out again before you predict.

An ammeter goes in series in the path you measure; a voltmeter goes across the two points you measure. The whole circuit's resistance needs the whole p.d. and the total current. Record readings with units and say where each was taken. 1 mA = 0.001 A; 1 mV = 0.001 V; 1 kΩ = 1000 Ω.

Back to circuit symbols

Practise exam questions

Write your answer first, then tick the mark points it makes.

Exam-style question

Two resistors are connected in parallel to a cell. State how the currents in the resistors are related to the current from the cell, and how the potential differences across them compare. [2]

Saved on this browser only. Anyone using this browser can see it.

Exam-style question

A 12 V battery of negligible internal resistance is connected to a 2.0 Ω resistor in series with a parallel pair of resistors of 6.0 Ω and 3.0 Ω. Calculate the current from the battery and the current in the 6.0 Ω resistor. [4]

Saved on this browser only. Anyone using this browser can see it.

Exam-style question

A 4.0 Ω resistor and an 8.0 Ω resistor are connected in series to a 6.0 V battery of negligible internal resistance. Calculate the current in the circuit and the potential difference across the 8.0 Ω resistor. [3]

Saved on this browser only. Anyone using this browser can see it.

Quick recall

Card 1 of 7. Answer in your head, then check.

Which of these is true of the circuit symbol for a cell? (A) Either line can be positive; the symbol does not show it. (B) The longer line is the positive terminal. (C) The shorter line is the positive terminal.

Review a topic

Read whole chapter

Next chapter: Practical electricity