Lesson 2 of 13
A beam crossing an electric field
I can describe and analyse charged-beam deflections in uniform electric and uniform magnetic fields.Syllabus
Syllabus 9478, 17(l). Describe and analyse charged-beam deflections in uniform electric and uniform magnetic fields.
Make a guess. You are not marked.
An electron beam enters the gap between two charged plates, moving at right angles to the field. What happens to its speed along the plates while it is between them?
Show the answer
It stays the same: there is no force that way.
The electric force acts along the field only. Along the plates, across the field, there is no force, so that part of the velocity does not change.
A charged particle that enters a uniform electric field at right angles keeps its speed across the field. It speeds up along the field. So its path is a parabola, like a ball thrown sideways.
Split the motion into two parts at right angles. Across the field there is no force, so that part of the velocity stays the same. Along the field the force is constant, so that part changes at a steady rate. Use the equations for constant acceleration for each part on its own.
Worked electron beam
Find where the electron leaves the plates
An electron enters the gap between two plates at 2.00 × 107 m/s, moving right. The field is 4000 N/C downward. The plates are 0.0600 m long and 0.0300 m apart, and the electron enters halfway between them. Ignore gravity.
An electron bends towards the positive plate
Both axes use the same scale, so the small bend is drawn true to size. The horizontal speed stays the same, so the total speed grows. After the plates, the path is a straight line.
Take right and up as positive. From the last lesson, the force on the electron is up and a = 7.03 × 1014 m/s2.
t = 0.0600 / (2.00 × 107) = 3.00 × 10-9 s
Upward shift: y = ½at2
= ½ × 7.03 × 1014 × (3.00 × 10-9)2
= 3.16 × 10-3 m
Upward velocity: vy = at = 2.11 × 106 m/s
The shift of 3.16 mm is less than half the gap, 15.0 mm, so the electron does not hit the top plate.
v = √((2.00 × 107)2 + (2.11 × 106)2)
= 2.01 × 107 m/s
Direction: tan θ = vy/vx = 0.105
θ = 6.0° above the horizontal
The horizontal speed did not change, but the total speed grew a little, because the field did work on the electron. After the plates there is no force, so the electron moves on in a straight line.
A positive particle would bend the other way, towards the negative plate. How far a particle bends also depends on its mass and its speed.
A real example. Before 1897, attempts to bend cathode rays with an electric field had failed. J. J. Thomson pumped nearly all the gas out of his tube. Then the rays did bend in an electric field, as charged particles should. Cathode rays turned out to be beams of electrons.
Between the plates the path is a parabola, not part of a circle, because the force always points the same way. Mark schemes also want the reason the horizontal velocity stays constant: there is no horizontal force.
The electric fields chapter treats the same motion using potential and energy.
Check your understanding
An electron enters a uniform downward electric field moving horizontally right. Neglect other forces. While it is inside the field, which of these descriptions is correct?
Show the answer
It accelerates upward, keeps its rightward velocity component, and so its total speed increases.
There is no horizontal force, so v_x stays fixed. The upward force creates an increasing upward component v_y; the total speed sqrt(v_x2 + v_y2) therefore increases from its entry value.