Lesson 4 of 13
Fields of a flat coil and a solenoid
I can sketch fields due to a long straight wire, a flat circular coil and a long solenoid.Syllabus
Syllabus 9478, 17(b). Sketch fields due to a long straight wire, a flat circular coil and a long solenoid.
Make a guess. You are not marked.
The current in a long solenoid is reversed but kept the same size. What happens to its magnetic field?
Show the answer
Same pattern and size, but it points the other way.
The grip rule gives the field direction from the current. Reverse the current and the field reverses everywhere, so the north and south ends swap.
The field of a flat coil passes straight through its middle. Inside a long solenoid the field is strong and nearly uniform. Outside, it looks like the field of a bar magnet.
Flat circular coil
Curl the fingers of your right hand the way the current goes round the coil. Your thumb then points along the field through the centre. Seen from the front, an anticlockwise current gives a field coming out towards you. A clockwise current gives a field going away from you.
Flat coil, seen face on
Here the dot in the middle is the field, not a current. You are looking from the right-hand side of the next drawing.
Flat coil, cut through its middle
The dot and the cross are the two cut ends of the wire, not field symbols.
Long solenoid, cut along its axis
The right end acts as a north pole and the left end as a south pole. The field is uniform only in the middle, away from the ends.
Long solenoid
A solenoid is a long coil with many turns. Inside it, away from the ends, the field lines are straight, parallel and evenly spaced, so the field there is uniform. At the ends the lines spread out. Outside, they loop back from the north end to the south end, and the field is much weaker.
Use the same grip rule. Your thumb points along the field inside the solenoid, towards its north end. Reverse the current and the two poles swap.
Map a field with a compass
Put a small compass at many points around the coil. Mark the way its north end points, then join the marks with smooth lines. Repeat with the current off, to see how much of the pattern is Earth's own field.
A real example. Most hospital MRI scanners use a superconducting magnet of 1.5 T or 3 T. The patient lies inside a tube about 60 to 70 cm wide, where the field is strong and very even. Earth's field is only 25 to 65 microtesla, so a 1.5 T scanner is over 20 000 times stronger.
Inside a solenoid, draw the lines straight and evenly spaced, and spread them out only at the ends. Bunching the lines at the ends, or drawing small circles round each turn, loses marks.
Check your understanding
You look at the face of a flat circular coil, and the current flows anticlockwise. Which of these is the direction of the magnetic field at the centre of the coil?
Show the answer
Out of the coil, towards you.
Curl the fingers of your right hand anticlockwise, the way the current goes. Your thumb points towards you, along the field through the centre.