Lesson 5 of 7
Measuring refractive index
I can apply the constant sine ratio to new situations and calculations.Syllabus
Syllabus K326 / K327, 11(d). Apply the constant sine ratio to new situations and calculations.
Make a guess. You are not marked.
A student shines a ray from air into a glass block at 20, 40 and 60 degrees to the normal. Each time she works out sin i / sin r. What should she find?
Show the answer
About the same value each time.
For light going from air into one medium, sin i / sin r is constant. It equals the refractive index of the glass. Small differences come only from errors in measuring.
To find the refractive index of a glass block, trace a ray through it. Measure i and r, then work out sin i / sin r.
For light going from air into a material, n = sin i / sin r. Both angles are measured from the normal.
Trace the ray
- Draw round the block on paper and keep it on that outline. Aim a narrow ray at one face, at an angle.
- Mark the points where the ray enters and leaves the block. Mark two more points, far apart, on the incident ray and on the emergent ray.
- Take the block away. Join the entry point to the exit point to draw the ray inside the block. Draw each outside ray through its marks.
- Draw the normal at the entry point. Put the centre of the protractor there and measure i and r from the normal.
- Repeat for several angles of incidence above zero. Work out sin i / sin r each time and compare the values.
You can also trace the path with pins. Stand two pins upright, well apart, on one side of the block. Look through the block from the other side. Place two more pins so that all four seem to be in one straight line, with no parallax between them. Keep the block still while you do this.
Get good readings
Three mistakes change the angles you measure. They are measuring from the surface, letting the block shift, and putting the marks too close together. A thin ray, a careful outline and marks that are far apart each deal with a different error. Use a protractor marked in degrees and read it with its centre on the entry point.
Plot sin i on the vertical axis against sin r on the horizontal axis. For light going from air into the block, the points should lie close to a straight line through the origin. Its gradient is n.
Expect a small scatter in your measured ratios. Real readings never match a calculated table exactly, so do not copy calculated values as your results.
Do not use the ray along the normal. At normal incidence the ray does not bend, so i = r = 0. The ratio becomes 0/0, which cannot give n.
Check your understanding
A ray enters a plastic block from air. A student measures the angle of incidence as 40 degrees and the angle of refraction as 25 degrees. Which of these gives the refractive index of the plastic?
Show the answer
sin 40 / sin 25 = 0.643 / 0.423 = 1.52
For light entering from air, n = sin i / sin r. The angle in air goes on top. The answer is greater than 1, as it must be for a solid.
Practise an exam question
Write your answer first, then tick the mark points it makes.
Exam-style question
A student shines light from air into a plastic block at several angles. She plots sin i (vertical axis) against sin r (horizontal axis). The best-fit line is straight, passes through the origin and through (0.40, 0.60). Find the refractive index of the plastic and explain how the graph shows this. [3]
Saved on this browser only. Anyone using this browser can see it.