Lesson 4 of 6
Measuring density
I can apply density = mass / volume to new situations.Syllabus
Syllabus K223 / K224, 3(g). Apply density = mass / volume to new situations.
Make a guess. You are not marked.
A student lowers a stone into a measuring cylinder of water to find its density. An air bubble sticks to the stone under the water. How does this change the density she calculates?
Show the answer
It comes out too small, because the measured volume is too large.
The bubble pushes up the water level as well as the stone, so the rise is bigger than the stone's volume. Dividing the mass by a volume that is too large gives a density that is too small.
In short
- Measure the mass on a balance.
- For an irregular solid, its volume is the rise in water level in a measuring cylinder.
To find a density, measure the mass on a balance and find the volume. How you find the volume depends on the object's shape.
Density = mass / volume.
An irregular solid: use displacement
Weigh the solid on a balance. Part-fill a measuring cylinder with water and read the level. Lower the solid in until it is completely under water, then read the level again. The rise in the level is the solid's volume.
Measured mass of the irregular solid: 64.8 g
The small scale divisions are not drawn.
Before immersion
After full immersion
Solid volume = 62 - 38 = 24 cm3
Density = 64.8 / 24 = 2.7 g/cm3.
| Quantity and unit | Reading |
|---|---|
| Mass of solid / g | 64.8 |
| Water level before / cm3 | 38 |
| Water level after / cm3 | 62 |
Worked example
Volume first, then density
- Volume: V = 62 - 38 = 24 cm3.
- Density: ρ = 64.8 / 24 = 2.7 g/cm3.
For a good result, the solid must sink, and it must not dissolve or soak up water. No water should splash out. Remove any air bubbles stuck to the solid. Read the bottom of the meniscus, with your eye level with it.
A famous story says Archimedes saw the water level rise as he stepped into a bath. He realised this could measure the volume of an oddly shaped object. The story was first written down by Vitruvius about two centuries later, and some scholars doubt it.
A regular solid: measure its sides
For a cuboid, measure its length, width and height with a ruler, and multiply them to get the volume.
A regular block
Mass: 64.8 g. Measure its length, width and height.
Volume = 4.0 x 3.0 x 2.0 = 24 cm3
Density = 64.8 / 24 = 2.7 g/cm3.
V = 4.0 x 3.0 x 2.0 = 24 cm3, so ρ = 64.8 / 24 = 2.7 g/cm3.
A liquid: take away the container
- Weigh an empty, dry measuring cylinder.
- Pour in some liquid and read its volume.
- Weigh the cylinder with the liquid. Take away the empty cylinder's mass to get the liquid's mass.
- Divide the liquid's mass by its volume.
For example, an empty cylinder has a mass of 42.6 g. With 50 cm3 of liquid in it, the mass is 82.6 g. The liquid's mass is 82.6 - 42.6 = 40.0 g, so its density is 40.0 / 50 = 0.80 g/cm3.
Read the volume of the liquid at eye level, using the measuring cylinder correctly.
Use the rise, not the final reading. The solid's volume is the second reading minus the first. Dividing by the final reading counts the water as part of the solid.
Check your understanding
A 96 g insoluble solid is fully submerged without trapped air or water loss. The cylinder reading rises from 40 to 72 cm3. What is its density?
Show the answer
3.0 g/cm3
The solid occupies the increase in volume: 72 - 40 = 32 cm3. Density = mass / volume = 96 / 32 = 3.0 g/cm3.
Practise an exam question
Write your answer first, then tick the mark points it makes.
Exam-style question
A stone of mass 62.4 g is lowered into a measuring cylinder containing water. The water level rises from 50.0 cm3 to 74.0 cm3. Calculate the density of the stone in g/cm3 and in kg/m3. [3]
Saved on this browser only. Anyone using this browser can see it.