K223 / K224 / 2027
Electric charge and current of electricity overview

Chapter revision

Revision summary

Key ideas, equations and common mistakes. Open any topic below for the full explanation.

Charge and current

Charge is positive or negative and is measured in coulombs, C. Like charges repel; unlike charges attract. A neutral object has equal amounts of positive and negative charge. Attraction alone does not prove that two objects have opposite charges.

Charge, Q
Unit: coulomb, C. 1 C = 1 A s. For a steady current, Q = It. Change minutes to seconds and milliamperes to amperes: 1 mA = 0.001 A.
Current, I
The rate of flow of charge. Unit: ampere, A = C/s. I = Q/t gives the average current over the time.
Direction
Outside the cell, conventional current flows from + to -. Electrons in the wire flow the opposite way. A component transfers energy; it does not use up the charge.

Energy per charge

E.m.f., E
The work done by a source in driving a unit charge around a complete circuit. Unit: volt, V = J/C.
Potential difference, V
The work done in driving a unit charge through a component. Also in volts. W = VQ. 1 mV = 0.001 V.

Ammeters and voltmeters

Ammeter: in series, with a very low resistance. Voltmeter: in parallel, across the component, with a very high resistance. Join each + terminal to the side nearer the cell's +, and pick a range bigger than the reading you expect.

Resistance and wires

Resistance, R
R = V/I; V = IR; I = V/R. Unit: ohm, Ω = V/A. Use the p.d. across and the current through the same component, from the same reading.
Wire dimensions
Same material and temperature: R ∝ L and R ∝ 1/A. For a round wire, A ∝ d2. Twice the length and twice the diameter give half the resistance.
Investigating length
Measure the active length between the contacts. Keep the current small so the wire stays at the same temperature. Plot R against L: a straight line through the origin.
Back to electric charge

Practise exam questions

Write your answer first, then tick the mark points it makes.

Exam-style question

A cell is connected to a lamp. Distinguish between the electromotive force (e.m.f.) of the cell and the potential difference (p.d.) across the lamp. [2]

Saved on this browser only. Anyone using this browser can see it.

Exam-style question

Define electric current. A current of 0.40 A flows through a lamp for 5.0 minutes. Calculate the charge that passes through the lamp. [3]

Saved on this browser only. Anyone using this browser can see it.

Exam-style question

Define the resistance of a component. When the potential difference across a resistor is 6.0 V, the current in it is 0.25 A. Calculate its resistance. [3]

Saved on this browser only. Anyone using this browser can see it.

Quick recall

Card 1 of 8. Answer in your head, then check.

Two small charged balls, separately suspended and isolated from other charged objects, repel. What can be concluded about their charge signs?

Review a topic

Read whole chapter

Next chapter: D.C. circuits