Lesson 2 of 12
Electric field of a point charge
I can recall and use the inverse-square field strength of a point charge in free space or air.Syllabus
Syllabus 9478, 14(b). Recall and use the inverse-square field strength of a point charge in free space or air.
Make a guess. You are not marked.
A point charge produces an electric field strength of 900 N/C at 0.10 m from it. What is the field strength at 0.30 m from it?
Show the answer
100 N/C, because the field falls with the square of the distance.
For a point charge E = Q / (4 pi epsilon0 r2). Three times the distance divides the field by 32 = 9, so 900 / 9 = 100 N/C.
Electric field strength at a point is the electric force per unit charge on a positive charge placed at that point. Around a point charge Q, it is E = Q/(4πε0r2).
Field strength
A charge sets up an electric field around it: a region where other charges feel a force. To measure the field at a point, imagine putting a small positive test charge q there.
Electric field strength E at a point is the electric force per unit charge on a positive charge placed at that point. So E = F/q, in N/C. The test charge must be small, so that it does not push the source charges out of place.
E is a vector. It points the way a positive charge would be pushed: away from a positive source and towards a negative one.
The field of a point charge
Put a test charge q at distance r from a source charge Q. Coulomb's law gives the force on q. Divide by q, and what is left depends only on the source:
So the field also follows an inverse-square law. Three times as far away, it is nine times weaker.
The force on any charge: F = qE
Once you know E at a point, the force on any charge q there is F = qE. A positive charge is pushed along E. A negative charge is pushed the opposite way.
Worked example
A negative charge near a positive source
A fixed source Q = +4.00 nC has a test charge q = -2.00 nC at r = 0.300 m. Take outward as positive, and 1/(4πε0) = 9.00 × 109 N m2 C-2.
F = qE = (-2.00 × 10-9)(400) = -8.00 × 10-7 N
The field points outward, but the force on the negative charge points inward, towards Q. Swap in a +2.00 nC charge and the force becomes 8.00 × 10-7 N outward. The field stays at 400 N/C, because it belongs to the source.
Same field, different test charges
Q = +4.00 nC and the 0.300 m distance stay the same. Teal is the field E at q; purple shows the forces, drawn to a different scale.
Negative test charge: attraction
Positive test charge: repulsion
The two forces act on different charges, so they never cancel. The field at q belongs to the source and does not change when q is swapped.
Check your understanding
A fixed positive source produces an outward field of 400 N/C at a point. Replace a small -2.00 nC test charge there with +2.00 nC, keeping the source unchanged. What happens?
Show the answer
The field stays 400 N/C outward; the test-charge force becomes 8.00 x 10-7 N outward.
E is unchanged in the test-charge approximation. Multiplying by positive q gives a force along E, with magnitude (2.00 x 10-9)(400) = 8.00 x 10-7 N.
A real example. Air stops insulating and sparks when the field in it reaches about 3 × 106 N/C. Outside a charged metal sphere, the field is the same as if all its charge sat at the centre. So a sphere of radius 0.10 m sparks once its charge reaches about (3 × 106)(0.10)2/(8.99 × 109) = 3 × 10-6 C: only a few microcoulombs.
Use the 9478 syllabus words: the electric force per unit charge on a positive charge placed at that point. In recent prelim mark schemes, leaving out "positive" was the most common way to lose this mark. The older 9749 syllabus said "force per unit positive charge", so past-year answers may be worded that way.