9478 / 2027
Electric Fields overview

Lesson 5 of 12

Field strength from potential gradient

  • I can recall and use field strength as the negative potential gradient.Syllabus

    Syllabus 9478, 14(f). Recall and use field strength as the negative potential gradient.

Make a guess. You are not marked.

A graph of electric potential V against position x is flat at +50 V between x = 0.10 m and x = 0.20 m. What is the electric field strength in that region?

  1. Zero, because the potential does not change with x there.
  2. 500 N/C, from 50 V divided by the 0.10 m width.
  3. 50 N/C, because the potential there is 50 V.
Show the answer

Zero, because the potential does not change with x there.

E = -dV/dx. A flat graph has zero gradient, so there is no field and no force on a charge, even though V is 50 V.

The electric field strength at a point equals the negative of the potential gradient there: E = -dV/dx. The field points from high potential to low potential.

Why E = -dV/dx

Let a charge q move a small distance Δx along a field E. The field does work qEΔx on it. That work equals the potential energy lost, -qΔV. Divide both sides by qΔx:

E = -dV/dx
Point charge, with r measured outward: Er = -dV/dr

The minus sign means the field points the way V falls. The units match: 1 V/m = 1 J/(C m) = 1 N/C.

On a graph of V against x, E at a point is minus the gradient of the tangent there. A steep graph means a strong field. A flat graph means no field, however large V is.

Worked example

Read the tangent, not a chord

For Q = +4.00 nC, V = 36.0/r. The tangent at (0.300 m, 120 V) passes through the guide points (0.200 m, 160 V) and (0.400 m, 80 V).

Use the slope at the point, not the height

This is the curve V = 36/r for Q = +4.00 nC, with r in metres and V in volts.

At r = 0.300 m, take the negative tangent gradient

The tangent at 0.300 metres has gradient -400 V/mThe curve V = 36/r, with filled dots at 0.200 metres and 180 volts, 0.300 metres and 120 volts, and 0.400 metres and 90 volts. A dashed tangent touches it at 0.300 metres and passes through hollow guide points at 160 volts and 80 volts. Its gradient is minus 80 volts over 0.200 metres, minus 400 volts per metre, so the field is 400 newtons per coulomb outward.0.2000.3000.400080120160200240Δr = +0.200 mΔV-80 VV / Vr / m

Filled dots are on the curve; hollow squares are on the tangent. Gradient = -80/0.200 = -400 V/m, so Er = -dV/dr = 400 N/C outward. A line through the filled dots at 0.200 and 0.400 m has a different slope.

The tangent touches the curve at 0.300 m. Its gradient, not the height of 120 V, gives the field.
Gradient = (80 - 160)/(0.400 - 0.200) = -400 V/m
Er = -(-400) = +400 N/C, outward

This matches Q/(4πε0r2) = 400 N/C from the field lesson. A chord through the curve at 0.200 m (180 V) and 0.400 m (90 V) gives -450 V/m instead. That is an average over the gap, not the value at 0.300 m.

Check your understanding

Outward radial distance is positive. The tangent to V(r) at r = 0.300 m passes through the guide points (0.200 m, 160 V) and (0.400 m, 80 V). What is the radial electric field there?

  1. +400 N/C, outward.
  2. -400 N/C, inward.
  3. +120 N/C, because the potential at the contact point is 120 V.
Show the answer

+400 N/C, outward.

The tangent gradient is (80 - 160)/(0.400 - 0.200) = -400 V/m. E_r = -dV/dr therefore gives +400 V/m = +400 N/C, outward.

Turned round, the area under a graph of E against x between two points is the potential difference between them.

A real example. On a fine day, the potential of the air rises by about 100 V for each metre above flat ground. Scientists call this the atmospheric potential gradient, and Francis Ronalds was recording it around 1810. Since V rises upward, E points down, at about 100 N/C.

Take the field from the gradient of a V-x graph, not its height. Keep the minus sign: where V falls as x rises, E points along +x.