9478 / 2027
Oscillations overview

Lesson 9 of 9

Useful and unwanted resonance

  • I can explain useful and unwanted examples of forced oscillations and resonance.Syllabus

    Syllabus 9478, 9(l). Explain useful and unwanted examples of forced oscillations and resonance.

Make a guess. You are not marked.

A washing machine drum speeds up during a spin. The floor shakes hardest at one middle speed, then calms down at full speed. What explains this?

  1. The drum pushes hardest at that speed, then the motor eases off.
  2. The water drains out at that speed, so the drum is unbalanced then.
  3. At that speed, the drum's turning frequency matches a natural frequency of the floor.
Show the answer

At that speed, the drum's turning frequency matches a natural frequency of the floor.

The spinning drum is a driver. When its frequency matches a natural frequency of the floor, resonance gives a large amplitude. At full speed the driving frequency is past that natural frequency, so the amplitude falls.

Resonance is useful when we want a big response at one frequency, and harmful when a big response could cause damage.

For each case, name the driver, the system that responds, and where the energy goes.

Useful resonance

A swing. The pushes are the drive. Pushing once per swing, in time with its natural frequency, adds energy every cycle, so the swing goes higher.

Musical instruments. A guitar's hollow body and the air inside it resonate with the strings. They pass the vibration to the air, so the note is louder.

A real example. Singapore's Class 95 radio station broadcasts at 95.0 MHz. Tuning a radio to it sets the natural frequency of a circuit inside the radio to 95.0 MHz. The circuit then resonates with that station's signal and responds very little to stations at other frequencies.

Unwanted resonance

Machines. A motor, or a washing machine's drum, shakes its supports at the frequency it turns. If that matches a natural frequency of the floor or a panel, it can vibrate hard and crack. Engineers add damping, or change the mass or stiffness to move the natural frequency away from the driving frequency.

Buildings and bridges. Wind, earthquakes and footsteps can drive a structure near its natural frequency. Dampers keep the amplitude down.

Check your understanding

A pump on a floor runs at 25 Hz. The floor has a natural frequency of 24 Hz and shakes badly. Which of these changes would reduce the shaking most?

  1. Run the pump at 24 Hz, so it matches the floor exactly.
  2. Stiffen the floor, so its natural frequency rises well above 25 Hz.
  3. Take away the rubber damping pads, so that the floor can move more freely.
Show the answer

Stiffen the floor, so its natural frequency rises well above 25 Hz.

Natural frequency rises with stiffness. Moving it well away from the 25 Hz drive takes the system off resonance, so the amplitude falls.

Investigating resonance

Drive an oscillator with a vibration generator. Change the driving frequency in small steps. At each step, wait for the motion to settle, then measure the amplitude from equilibrium. Keep the size of the drive, the mass and the spring the same. To see the effect of damping, add damping, such as a card in the air, and repeat.

Changing the mass or stiffness changes the natural frequency. Check whether the change moves it towards the driving frequency or away from it.