Lesson 3 of 7
Measuring a force pulse
I can use the area under a body's force-time graph to calculate impulse and solve problems.Syllabus
Syllabus 8867, 6(a). Use the area under a body's force-time graph to calculate impulse and solve problems.
Make a guess. You are not marked.
A force sensor fixed to a wall records a ball's impact as a positive force, with towards the wall positive. What is the sign of the force on the ball?
Show the answer
Negative: the wall pushes the ball away from the wall.
The sensor measures the ball's push on the wall. By Newton's third law, the wall's push on the ball is equal and opposite.
A force sensor records force against time during an impact. The area under its graph is the impulse, which you can compare with the measured change in momentum.
First decide which force the sensor measures. A sensor fixed to a wall measures the ball's push on the wall. The force on the ball is equal and opposite, so reverse the sign before you compare it with the ball's Δp.
- Calibrate and zero: check the sensor with a known force, and set it to read zero when nothing touches it.
- Record the whole pulse: from before contact until the force is back to zero. Take readings often enough to catch the peak.
- Measure the same impact: find the ball's mass and its velocities just before and just after contact.
- Compare: the area under the graph, in N s, with m(v - u), in kg m/s.
Readings taken too far apart can miss the peak, so the area comes out too small. A wrong zero adds a false area over the whole contact. For example, a sensor that reads +10 N with nothing on it adds 10 × 0.060 = +0.60 N s. The true -4.80 N s then shows as -4.20 N s. Repeating the measurement does not remove this error.
| Time / ms | Force on ball / N |
|---|---|
| 0 | 0 |
| 20 | -160 |
| 60 | 0 |
A real example. NIST, the US measurement institute, calibrates force sensors with its Million Pounds-Force Deadweight Machine. A three-storey stack of steel disks hangs from the sensor. Each step adds another 50,000 pounds of steel, about 220 kN, pulling on it. Known weights give known forces to check the readings against.
Check which body the measured force acts on. A sensor in the wall gives the ball's push on the wall, which has the opposite sign to the force on the ball.
Check your understanding
A force sensor reads +5.0 N when nothing touches it. Its graph of a 0.040 s impact on a ball gives an area of -2.30 N s. Which of these is the true impulse on the ball?
Show the answer
-2.50 N s
The wrong zero adds +5.0 N for the whole 0.040 s, a false +0.20 N s. Remove it: -2.30 - 0.20 = -2.50 N s.