Lesson 5 of 8
The output of an a.c. generator
I can sketch output voltage against time for a simple a.c. generator.Syllabus
Syllabus K323, 19(c). Sketch output voltage against time for a simple a.c. generator.
Make a guess. You are not marked.
A simple a.c. generator turns at a steady rate and gives an output voltage of peak value 6 V at 50 Hz. The coil is now turned twice as fast. What happens to the output?
Show the answer
The peak rises to 12 V and the frequency to 100 Hz.
Turning faster cuts the field lines at twice the rate, so the induced e.m.f. doubles. One turn now takes half the time, so the frequency doubles too.
As the coil turns, the output voltage rises and falls in a smooth wave. It reverses every half turn.
The slip rings keep each end of the coil joined to the same brush, so the output can reverse.
One turn, step by step
We look along the axle. The field points right, and the coil turns clockwise. The output is the voltage at A minus the voltage at B.
Follow A and B through one turn
We look along the axle from the front. The coil turns clockwise and the field points right. The circles are sides A and B. The dashed line is the coil seen edge-on.
The output is the voltage at A minus the voltage at B. Blue arrows show how the sides move.
1. Start: 0 s
0 VPlane perpendicular to the field
A is at the top and B at the bottom. They move along the field lines, so they cut none. The output is zero.
2. One quarter-turn: 0.010 s
+6.0 VPlane parallel to the field
A is on the right, moving down. B is on the left, moving up. They cut across the field lines fastest. A is +, so the output is at its positive peak.
3. Half a turn: 0.020 s
0 VPlane perpendicular to the field
A and B have swapped places: A is at the bottom, B at the top. They move along the field lines again, so the output is zero.
4. Three quarters of a turn: 0.030 s
-6.0 VPlane parallel to the field
A is on the left, moving up. B is on the right, moving down. They cut across the field lines fastest, the other way. A is -, so the output is at its negative peak.
5. One complete turn: 0.040 s
0 VPlane perpendicular to the field
A is at the top again after one full turn, so one cycle is complete. The next cycle begins.
The same five moments on a graph
The coil turns at a steady rate in a uniform field. Its peak output is 6.0 V and one turn takes 0.040 s.
The output is zero when the plane of the coil is at right angles to the field. The most field passes through the coil then, but for a moment it is not changing. The output is largest when the plane of the coil is along the field. The sides then cut the field lines fastest.
Sketch the graph
Put the output voltage on the vertical axis and time on the horizontal axis. Draw a smooth wave, a sine curve, not straight lines. Mark the peak voltage and the time for one turn.
One turn takes 0.040 s, so the period T = 0.040 s. The frequency is f = 1/T = 1/0.040 = 25 Hz. That means 25 turns each second.
Changing the output
| Change | Peak voltage | Frequency |
|---|---|---|
| Turn the coil faster | Higher | Higher: each turn takes less time |
| Use a stronger magnet | Higher | The same |
| Use more turns on the coil | Higher | The same |
Turning faster makes the field through the coil change faster, so the peak rises. Each turn also takes less time, so the frequency rises too. A stronger field or more turns raise only the peak.
Singapore's mains supply has a frequency of 50 Hz. A power station generator with two magnetic poles must turn 50 times a second to give it. That is 3000 turns a minute.
Turning faster changes two things. To raise the peak without changing the frequency, use a stronger magnet or more turns. Turning faster also raises the frequency.
Check your understanding
A coil rotates uniformly in a uniform magnetic field. At t = 0 its plane is perpendicular to the field. Why is the instantaneous output zero at that position in the stated generator model?
Show the answer
The flux through the coil is greatest at this moment, but its rate of change is zero.
Induction depends on change. At this orientation the field through the rotating coil is at a turning point, so output is zero. A quarter-turn later the plane is parallel to the field and output has maximum magnitude.