Skip to notes
9476 / 2027
The Mole Concept and Stoichiometry

Lesson 6 of 6

Deduce a ratio from measurements

Use back titration, loss of water and reacting amounts to find an unknown ratio.

A-Level 9476 (2026-2027)

  • I can calculate reacting amounts in solids, gases and solutions.Syllabus

    Syllabus 9476, 6(g). Calculate reacting amounts in solids, gases and solutions.

  • I can deduce stoichiometric relationships from measurements.Syllabus

    Syllabus 9476, 6(h). Deduce stoichiometric relationships from measurements.

Use the measured difference to reveal an unknown ratio

When you cannot measure an amount directly, measure what is left over or what is lost, then compare amounts to find the ratio.

Make a guess. You are not marked.

0.0100 mol of a metal M reacts with exactly 0.0300 mol of HCl. What is the formula of the metal chloride?

  1. MCl3
  2. M3Cl, from the 3 in the ratio
  3. MCl, as each HCl has one Cl
Show the answer

MCl3

The ratio M : HCl is 1 : 3, so each M atom gains three Cl. Aluminium behaves this way: 2Al + 6HCl -> 2AlCl3 + 3H2.

Deducing a ratio relies on a law from 1797. Joseph Proust stated that a compound always contains its elements in a fixed ratio by mass, wherever it comes from. Claude Louis Berthollet opposed him, arguing that elements could combine in any proportion.

Worked exampleBack titration measures acid used by the sample

A 0.5000 g sample containing CaCO3 and an inert impurity reacts with 50.00 cm3 of 0.2000 mol dm-3 HCl. After all CO2 is removed, titrating the entire remaining mixture uses 20.00 cm3 of 0.1000 mol dm-3 NaOH. Find the percentage CaCO3, using M = 100.1 g mol-1.

Try it first. Then show the worked stepsHide the worked steps
  1. Initial HCl = 0.01000 mol. Remaining HCl = n(NaOH) = 0.002000 mol.
  2. HCl consumed by the carbonate = 0.008000 mol.
  3. CaCO3 + 2HCl → CaCl2 + CO2 + H2O, so n(CaCO3) = 0.004000 mol.
  4. CaCO3 mass = 0.4004 g; percentage = 0.4004/0.5000 × 100.
Answer

80.08% CaCO3. This assumes the impurity does not consume acid and the remaining acid is all included in the titration. A titrated aliquot would require a separate scaling factor.

Worked exampleInfer water of crystallisation

Heating 2.50 g of CuSO4·xH2O to constant mass leaves 1.60 g anhydrous CuSO4. Use M(CuSO4) = 159.6 and M(H2O) = 18.0 g mol-1.

Try it first. Then show the worked stepsHide the worked steps
  1. Water lost = 0.90 g, giving 0.90/18.0 = 0.050 mol water.
  2. Anhydrous salt amount = 1.60/159.6 = 0.0100 mol.
  3. Water/salt ratio is approximately 4.99, consistent with x = 5.
Answer

CuSO4·5H2O, assuming the mass loss is only water and the salt itself does not decompose. Water left in the solid makes x too low; loss of solid or decomposition can make it too high.

Constant mass means you heat, cool and weigh, then repeat until two masses agree. Only then has all the water gone.

For an unknown reaction, calculate the amounts actually consumed, divide by their smallest common amount, then infer coefficients. A balanced atom-and-charge check is still necessary. An observed amount ratio can be distorted by excess unreacted reagent, side reactions or incomplete collection; it is not automatically the stoichiometric ratio.

Check your understanding

In a back titration, a carbonate sample reacts with a known excess of HCl, and the leftover acid is titrated with NaOH. What does the NaOH titre measure?

  1. The acid left over, which is subtracted from the acid added
  2. The carbon dioxide given off, which is dissolved and neutralised by the NaOH
  3. The acid used by the carbonate, which gives the moles of carbonate directly
Show the answer

The acid left over, which is subtracted from the acid added

Moles of HCl used by the sample = moles of HCl added - moles left over. The NaOH titre gives the moles left over.

Watch out for this

A student says: "To find x in a hydrated salt, heat it once until it changes colour, then weigh it. The mass lost is all the water." What is wrong with this?

Show the answer

Heat, cool and weigh, then repeat until two masses agree. If some water is left, the mass lost is too small and x comes out too low. A June 2021 Cambridge practical report says some candidates had apparently not heated strongly enough to remove all the water of crystallisation.

Exam-style question

Find the water of crystallisation in washing soda by titration. [6]

3.15 g of washing soda crystals, Na2CO3·xH2O, is dissolved in water and made up to 250.0 cm3 in a volumetric flask. A 25.00 cm3 portion needs 22.05 cm3 of 0.1000 mol dm-3 hydrochloric acid, with methyl orange as the indicator.
Na2CO3 + 2HCl → 2NaCl + CO2 + H2O
Use Mr(Na2CO3) = 106.0 and Mr(H2O) = 18.0.
(a) Calculate the amount of HCl used. [1]
(b) Calculate the amount of Na2CO3 in the 250.0 cm3 flask. [2]
(c) Calculate the relative formula mass of the crystals, and hence find x. [2]
(d) Washing soda crystals left open to dry air lose some of their water. Suggest how this would change the value of x found by this method. [1]

Saved on this browser only. Anyone using this browser can see it.