Skip to notes
8873 / 2027
Reaction Kinetics

Lesson 2 of 5

Concentration-time graphs and half-life

Tell zero order from first order and use a constant half-life.

A-Level 8873, revised syllabus (2026-2027)

  • I can construct and use simple rate equations.Syllabus

    Syllabus 8873, 7(b). Construct and use simple rate equations.

  • I can explain constant first-order half-life.Syllabus

    Syllabus 8873, 7(c). Explain constant first-order half-life.

Recognise zero and first order from the whole curve

A zero-order graph is a straight line; a first-order graph halves in equal times, so its half-life is constant.

Make a guess. You are not marked.

A reactant is zero order. Its concentration falls from 0.160 to 0.0800 mol dm-3 in 60 s. How long will it take to fall from 0.0800 to 0.0400 mol dm-3?

  1. 30 s, half as long as before
  2. 60 s, the same as before
  3. 120 s, twice as long
Show the answer

30 s, half as long as before

Zero order means a constant rate: 0.0800 mol dm-3 per 60 s. Losing 0.0400 mol dm-3 at that rate takes 30 s, so each halving is quicker than the last.

Two concentration-time patterns

Both illustrative curves start at 0.160 mol dm-3 at constant temperature. Zero-order concentration falls linearly to zero at 120 seconds. The first-order curve halves every 30 seconds and progressively flattens.

These are different illustrative models with the same starting concentration, not two simultaneous descriptions of one experiment. Integrated rate-law formulae are not required.

A zero-order concentration-time graph is a straight line while reactant remains, because the same amount is used up every second. Each halving then takes less time than the one before. A first-order graph curves, because the rate falls as the concentration falls. Its half-life stays the same, even if you start measuring from a later point.

Ludwig Wilhelmy is usually credited with the first quantitative study of a reaction rate. In 1850 he followed acids acting on cane sugar with a polarimeter, which measures how a solution rotates polarised light. He found that the rate was proportional to the concentration of sugar: first-order behaviour.

Read the first-order curve
Time / s0306090
[A] / mol dm-30.1600.08000.04000.0200

Worked exampleHalf-life is independent of the chosen starting concentration

Show how the table supports first order.

Try it first. Then show the worked stepsHide the worked steps
  1. 0.160 to 0.0800 takes 30 s.
  2. 0.0800 to 0.0400 also takes 30 s, despite the lower starting concentration.
  3. 0.0400 to 0.0200 again takes 30 s.
Answer

The constant 30 s halving interval supports first order. A falling curve alone is insufficient evidence: many rate laws produce falling curves.

Try it step by step

Work it out in steps: Number of half-lives, then Concentration remaining, then Percentage reacted.

  1. Problem 1. A first-order reactant has a half-life of 30.0 s and starts at 0.320 mol dm-3. Find its concentration after 90.0 s and the percentage reacted, to 3 significant figures.
  2. Problem 2. A first-order reactant has a half-life of 5.00 min and starts at 0.600 mol dm-3. Find the percentage reacted after 10.0 min, to 3 significant figures.
  3. Problem 3. A first-order reactant has a half-life of 40.0 s and starts at 0.480 mol dm-3. Find the number of half-lives in 160 s, then the concentration and percentage reacted to 3 significant figures.
Show the answer

Problem 1.

Number of half-lives: 90.0 / 30.0 = 3 half-lives.

Concentration remaining: 0.320 -> 0.160 -> 0.0800 -> 0.0400 mol dm-3.

Percentage reacted: 1/8 remains, so 7/8 has reacted: 87.5%.

Problem 2.

Number of half-lives: 10.0 / 5.00 = 2 half-lives.

Concentration remaining: 0.600 -> 0.300 -> 0.150 mol dm-3.

Percentage reacted: 1/4 remains, so 75.0% has reacted.

Problem 3.

Number of half-lives: 160 / 40.0 = 4 half-lives.

Concentration remaining: 0.480 -> 0.240 -> 0.120 -> 0.0600 -> 0.0300 mol dm-3.

Percentage reacted: 1/16 remains, so 93.75% has reacted, 93.8% to 3 significant figures.

With real data, draw a smooth curve through the points and read several halving times. Keep the temperature steady. If the mixture warms during the run, k changes and the shape of the curve is distorted. Treat an odd point with a reason. Do not delete it just to make the curve look ideal.

Watch out for this

A student says: "The concentration halves at 30 s and halves again at 60 s, so the first half-life is 30 s and the second is 60 s." What is wrong with this?

Show the answer

A half-life is a length of time, not a clock reading. The second half-life runs from 30 s to 60 s, so it is also 30 s. That equal time is the evidence for first order. A June 2022 Cambridge report says writing 'the second half-life is 60 s' does not support a constant half-life.